High Speed Point-to-Point Bridge works as virtual Ethernet cable to Wi-Fi enable any wired Intercom / Camera / Speaker / Phone.

• Forget Ethernet cable, the Ubiquiti NanoStation LOCO is ideal for bridging networks or sharing broadband between buildings
• To install, place the units at either end of the network and connect both to Ethernet cables – for example, connect the first unit into your modem at location one, and connect the second into an Ethernet switch or WiFi access point at the other location
• Face both units so they point towards each other and the link is established. Simple!
• This is a transparent data-link layer bridge, not a routed bridge – this means that you are creating a virtual ethernet cable between the two facilities, making network setup incredibly simple – no routing configuration, all protocols (DHCP, DNS, etc) just work
• Management of the Ubquiti device couldn’t be easier with SSH and SNMP protocol support, as well as a very intuitive HTTP interface.
• Connect two remote locations on the one network
• Share Internet connection between buildings, remote sites, etc.
• Up to 200mW output power, 2×2 MIMO operation, 100Mbps
• Integrated AirOS web software for controlling power, bridge/AP mode, etc.
• Includes POE injector and 240V AC adaptor
• Two units required for wireless Point to Point bridge.

Surge protection should be used for all outdoor installations. Ubiquiti recommend that you use two Ethernet Surge Protectors – model ETH-SP – place one near the NanoStation and the other at the entry point to the building. The ETH-SP will absorb power surges and safely discharge them into the ground.