High Speed Point-to-Point Bridge works as virtual Ethernet cable to Wi-Fi enable any wired Intercom / Camera / Speaker / Phone.
Forget Ethernet cable, the Ubiquiti NanoStation LOCO is ideal for bridging networks or sharing broadband between buildings
To install, place the units at either end of the network and connect both to Ethernet cables – for example, connect the first unit into your modem at location one, and connect the second into an Ethernet switch or WiFi access point at the other location
Face both units so they point towards each other and the link is established. Simple!
This is a transparent data-link layer bridge, not a routed bridge – this means that you are creating a virtual ethernet cable between the two facilities, making network setup incredibly simple – no routing configuration, all protocols (DHCP, DNS, etc) just work
Management of the Ubquiti device couldn’t be easier with SSH and SNMP protocol support, as well as a very intuitive HTTP interface.
Connect two remote locations on the one network
Share Internet connection between buildings, remote sites, etc.
Up to 200mW output power, 2×2 MIMO operation, 100Mbps
Integrated AirOS web software for controlling power, bridge/AP mode, etc.
Includes POE injector and 240V AC adaptor
Two units required for wireless Point to Point bridge.
Surge protection should be used for all outdoor installations. Ubiquiti recommend that you use two Ethernet Surge Protectors – model ETH-SP – place one near the NanoStation and the other at the entry point to the building. The ETH-SP will absorb power surges and safely discharge them into the ground.